Writing To The Variable Area - Omron K3HB - MANUAL 2 Manual

Writing to the Variable Area

1-6

Writing to the Variable Area

Command
Response
1-10
Write to the data area by setting the required data in the following FINS-mini
command text format.
FINS-mini Command Text
Starting
Variable address
MRC SRC
type of write
"01" "02"
2 2 2 4
Data name
MRC/SRC Specifies the FINS-mini monitor value/setting data write
command.
Variable type Specify a variable type.
First address of write Specify the address for the beginning of the write.
Bit position Not used on the K3HB. Specify "00".
Number of elements Specifies the number of variables to be written (max. of
24 (H'18)). Not needed for a compound write.
Write data Enter data to be written.
FINS-mini Response Text
Response code
MRC SRC
(MRES/SRES)
"01" "02"
2 2 4
Data name
MRC/SRC FINS-mini command text appears here.
Response code Result of execution of the command.
Response Codes
Response Error name
code
"1002" Command length too
short
"1101" Area type error
"1003" Number of elements/Data
number do not agree
"1100" Parameter error
"2203" Operation error
"0000" Normal end
Bit
Number of
position
elements Write data
"00" "0001" to "0018"
2 4
Explanation
Explanation
Explanation
The command is too short.
Incorrect variable type.
The specified number of elements does not
agree with the actual number of data ele-
ments.
Bit position specification other than "00".
Written data was outside of setting range.
Write via communications is disabled.
Write to setting area 1 was attempted from
setting area 0.
Write to setting data of protect level was
attempted from other than protect level.
Calibration level in progress.
Unit error, unit change, display unit error,
internal non-volatile memory error.
Section 1-6