Setting Data Compound Write (Compoway/F Communications); Monitor Value/Setting Data Compound Read Store (Write) - Omron K3HB - MANUAL 2 Manual

Commands and Responses (CompoWay/F Communications)
Response
1-9-6

Setting Data Compound Write (CompoWay/F Communications)

Command
Response
1-9-7

Monitor Value/Setting Data Compound Read Store (Write)

Command
1-16
MRC SRC
Response code
"01" "02" "0000"
Response codes: The above indicates a normal end. For the response codes,
see 1-6 Writing to the Variable Area (page 1-10).
Variable
type
MRC SRC Address
"01" "13"
Variable type
Variable type
"C1" to "C2" "0000" to "0004"
"C4" to "CB" "0000" to "0027"
Multiple setting data items can be written by sending a single command. Up to
12 items can be written even if the addresses are not contiguous.
To specify the variable type or address, see SECTION 2 List of Settings
(page 2-1).
Setting data of setting area 1 is written in setting area 1. An error will result if
written in setting area 0.
To use this command, "Write via communications" must be enabled using the
"Write via communications" operation command.
MRC SRC
Response code
"01" "13" "0000"
Response codes: The above indicates a normal end. For the response codes,
see 1-6 Writing to the Variable Area (page 1-10).
Variable
MRC SRC type Read address
"01" "11"
Variable type
"C0" "0000" to "0004"
"C1" to "C2" "0000" to "0004"
"C4" to "CB" "0000" to "0027"
This command is used to store the addresses of multiple monitor values or
setting data that you wish to read.
The stored monitor values or setting data can be read by sending a single
"Monitor value/setting data compound store read" command. Up to 20 items
can be stored, even if the addresses are not continuous.
Bit position Data
Setting data
"00"
Address
Bit position
Setting data
"00"
Address Setting data (explanation)
Setting data of setting area 0
Setting data of setting area 1
Variable
Bit position type Read address
"00"
Variable
type
Read address
Address Setting data (explanation)
Monitor values
Setting data of setting area 0
Setting data of setting area 1
Section 1-9
Data
Bit position
"00"
Bit position
"00"