Speakers - HP ZBook Fury G11 Maintenance And Service Manual

3. Detach the WWAN antenna transceiver (3) from the computer. The transceiver is attached with
double-sided adhesive.
To install the WWAN antenna, reverse the removal procedures.

Speakers

To remove the speakers, use this procedure and illustration.
Table 6-2 Speaker description and part number
Description
Speaker Kit (includes left and right speakers, cables, and four rubber isolators)
Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the service cover (see
components:
a. Battery (see
b. WWAN module thermal module (see
c. Memory module cover (see
Remove the speakers:
1. Disconnect the speaker cables (1) from the system board.
2. Release the left (2) and right (3) speaker cables from the retention clips built into the computer.
3. Remove the four Phillips M2.0 × 5.3 screws (4) that secure the speakers to the computer.
Service cover on page
Battery on page 42)
Memory modules on page
Preparation for disassembly on page
41), and then remove the following
WWAN module on page
47)
Spare part number
N19218-001
41).
45)
Speakers 59