Removal And Replacement Procedures For Authorized Service Provider Parts; Component Replacement Procedures; Touchpad Cable - HP ZBook Fury G11 Maintenance And Service Manual

6 Removal and replacement procedures for
authorized service provider parts
This chapter provides removal and replacement procedures for authorized service provider parts.
IMPORTANT:
chapter. Accessing these parts can damage the computer or void the warranty.
NOTE: Details about your computer, including model, serial number, product key, and length of
warranty, are on the service tag at the bottom of your computer.

Component replacement procedures

To remove and replace computer components, use the procedures described in this section.
NOTE: HP continually improves and changes product parts. For complete and current information
about supported parts for your computer, go to https://partsurfer.hp.com/partsurfer/, select your
country or region, and then follow the on-screen instructions.
Make special note of each screw size and location during removal and replacement.

Touchpad cable

To remove the touchpad cable, use this procedure and illustration.
The touchpad cable is available in the Cable Kit, spare part number N19223-001.
Before removing the touchpad cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the service cover (see
3. Remove the battery (see
Remove the touchpad cable:
1. Disconnect the touchpad cable (1) from the system board.
2. Disconnect the touchpad cable (2) from the touchpad.
Only an authorized service provider should access the components described in this
Service cover on page
Battery on page

Removal and replacement procedures for authorized service provider parts

Preparation for disassembly on page
41).
42).
41).
55