2.
Remove the service cover (see
components:
a.
Battery (see
b.
WWAN module thermal module (see
c.
Memory module cover (see
d.
Bottom case (see
e.
Fans (see
f.
System board (see
g.
Fingerprint reader (see
Remove the fingerprint reader cable:
■
Release the ZIF connector (1), and then disconnect the fingerprint reader cable from the fingerprint
reader (2).
To install the fingerprint reader cable, reverse the removal procedures.
Card reader
To remove the card reader, use this procedure and illustration.
Table 6-12
Card reader description and part number
Description
Card reader
Before removing the card reader, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the service cover (see
components:
74
Chapter 6 Removal and replacement procedures for authorized service provider parts
Service cover on page
Battery on page
42)
Memory modules on page
Bottom case on page
Fan on page
64)
System board on page
Fingerprint reader on page
Service cover on page
41), and then remove the following
WWAN module on page
47)
60)
66)
72)
Preparation for disassembly on page
41), and then remove the following
45)
Spare part number
N99108-001
41).