Card Reader Cable; Prepare The Computer For Disassembly (See Preparation For Disassembly - HP ZBook Fury G11 Maintenance And Service Manual

To replace the bottom case, reverse the removal procedures.

Card reader cable

To remove the card reader cable, use this procedure and illustration.
NOTE: The card reader cable is included in the Cable Kit, spare part number N19223-001.
Before removing the card reader cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the service cover (see
components:
a. Battery (see
b. WWAN module thermal module (see
c. Memory module cover (see
d. Bottom case (see
Remove the card reader cable:
1. Disconnect the card reader cable (1) from the system board.
2. Disconnect the card reader cable (2) from the card reader board.
62 Chapter 6 Removal and replacement procedures for authorized service provider parts
Service cover on page
Battery on page 42)
Memory modules on page
Bottom case on page
Preparation for disassembly on page
41), and then remove the following
WWAN module on page
47)
60)
41).
45)