Heat Sink - HP ZBook Fury G11 Maintenance And Service Manual

To install the system board, reverse the removal procedures.

Heat sink

To remove the heat sink, use these procedures and illustrations.
Table 6-8 Heat sink descriptions and part numbers
Description
NOTE: All heat sink spare part kits include captive screws and replacement thermal material.
Replacement thermal pads are also available in the Thermal Pad Kit, spare part number
N58142-001.
For use on models with an NVIDIA high-range graphics card
For use on models with an NVIDIA mid-range graphics card
For use on models with a graphic subsystem with UMA memory
Before removing the heat sink, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the service cover (see
components:
a. Battery (see
b. WWAN module thermal module (see
c. Memory module cover (see
d. Bottom case (see
e. Fans (see
f. System board (see
Remove the heat sink:
1. In the order indicated on the heat sink, loosen the eight captive Phillips screws (1) that secure the
the heat sink to the system board.
NOTE:
captive screws securing the heat sink to the computer.
Service cover on page
Battery on page
Memory modules on page
Bottom case on page
Fan on page 64)
System board on page
Computer models equipped with a graphics subsystem with UMA memory have only four
Preparation for disassembly on page
41), and then remove the following
42)
WWAN module on page
60)
66)
Spare part number
N19230-001
N50687-001
N19228-001
41).
45)
47)
Heat sink 69