Completing The Initial Commissioning Process - Miele PDR 914 Operating And Installation Instructions

Initial commissioning
Skipping payment
device set-up
18
Programme packages
Label Standard
Cottons  Cottons
Cottons PRO
Minimum iron
Swipe to the left with your finger until you reach a programme that is

not highlighted in orange.
Touch the programme to be activated.

The selected programme is now active and highlighted in orange.
You can select further programmes if required.
If you do not want to select any more programmes, confirm with

The display will change to the next setting.
Tip: You can disable a selected programme by touching the pro-
gramme again. Exception: The
grammes cannot be disabled.
Setting up a payment device
If you wish to set up a payment device, read the "Payment system"
section of the "Supervisor level" chapter. You can only make these
settings during initial commissioning. If you wish to change the set-
tings after the commissioning process, please contact the Miele Cus-
tomer Service Department.
If you do not wish to set up a payment device, you can skip this step.
Payment system
No payment
Timed
system
operation
Programme Timed op. +
control impul.counter
Touch the
No payment system

Touch to confirm.
OK

The display will change to the next setting.

Completing the initial commissioning process

The commissioning process is complete when a programme lasting
longer than 10 minutes has been carried out in full.
If the power is interrupted prior to the start of the first drying pro-
gramme (e.g. if the machine is switched off with the  button), the
initial commissioning process can be completed again. Once a drying
programme has been running for over 10 minutes, the initial commis-
sioning process cannot be performed again.
In the main menu, touch the  Programmes sensor control.

11:02
Woollens
Delicates
OK
Cottons 
11:02
COM module
OK
sensor control.
and pro-
Cottons PRO
.
OK