Res. Moisture Display; Visibility Parameters; Display Off Status - Miele PDR 914 Operating And Installation Instructions

-
Finish tone
The finish tone signals the end of the drying programme.
-
Keypad tone
-
Welcome tone
-
Fault alarm
The fault tone signals a fault and can be switched off. The volume of the fault tone cannot
be adjusted.

Res. moisture display

In addition to displaying the drying level, the residual moisture can also be indicated as a
percentage.
- Factory default:
Without % value
-
With % value

Visibility parameters

Various parameters are offered/displayed when a programme is selected. You can decide
which parameters should not be displayed. These parameters can then not be edited dur-
ing programme selection.
-
Residual moisture
-
Duration
-
Low temperature
-
Anti-crease
-
Load size
-
Drying temperature

Display off status

The display switches off to save energy; only the Start/Stop sensor flashes slowly. You can
change this setting.
Changing this setting leads to increased energy consumption.
-
Off
No switching off
-
On (10 min.) Not curr.prog.
The display will remain on during the programme sequence but will go out 10 minutes
after the end of the programme.
-
Logo (10 min.) Not curr.prog.
The display will remain on during the programme sequence but the logo will light up
10 minutes after the end of the programme.
- Factory default:
On after 10 min.
The display is switched off after 10 minutes.
-
On (30 min.) Not curr.prog.
The display will remain on during the programme sequence but will go out 30 minutes
after the end of the programme.
-
Logo (30 min.) Not curr.prog.
The display will remain on during the programme sequence but the logo will light up
30 minutes after the end of the programme.
-
On after 30 min.
The display will go out after 30 minutes.
Supervisor level
29