Configuring Snmp V1/V2 In The Gui; Configuring Snmp V3 In The Gui - ADTRAN NetVanta 1570 Series Configuration Manual

Configuring SNMP Using the GUI

Configuring SNMP v1/v2 in the GUI

g
NOTE
Select the circular question mark icon located at the top-right hand side of the blue menu bar
from any page in the GUI for detailed explanations of variables and valid character lengths for the
different entries.
Step 1: Enable SNMP and Enter Your SNMP Community Secret
1. Navigate to SNMP > SNMPv1/v2c. Toggle the Mode button to on.
2. Specify the community secret established for your SNMP polling server in the field to the right of the
corresponding v1/v2c community and ensure the communities that you plan to use are enabled. There are
typically two community strings defined: one intended for read only access and one intended for read/write
access.
3. Select Apply to save your changes.
Step 2: Enable the SNMP security Models (firmware v20.12-4 and earlier)
This step is only needed for firmware versions v20.12-4 and earlier.
The security models are turned off by default in firmware versions v20.12-4 and earlier. These security models,
which need to be enabled for SNMP to work on the ASE device, must be enabled in the CLI. See
Enable the SNMP security Models (firmware v20.12-4 and earlier) on page

Configuring SNMP v3 in the GUI

g
NOTE
Select the circular question mark icon located at the top-right hand side of the blue menu bar
from any page in the GUI for detailed explanations of variables and valid character lengths for the
different entries.
20
SNMP in the NetVanta 1570
Step 3:
10.
6AMCCG0018-29A