Command Summary - ADTRAN NetVanta 1570 Series Configuration Manual

Command Summary

5. Command Summary
Table 4. SNMP v1/v2 Configuration Command Summary
Step Command
Step 1 Download the ASE product-specific MIBS.
Step 2 Enable SNMP on the ASE Device.
(config)#snmp-server
Step 3
Enter Your SNMP Community Secret
(config)#snmp-server community
[public | private] ip-range [<ipv4
address> <subnet mask> |ipv6-range
<ipv6 address>] <community secret>
Step 4 Enable the SNMP Security Models (firmware v20.12-4 and earlier)
(config)#snmp-server
security-to-group model [v1|v2c]
name [public |private] group
[default_ro_group|default_rw_group
]
Step 5
Enable the Read and Write Community
(config)#snmp-server community
[readcommunity|writecommunity]
enable.
Table 5. SNMP v3 Configuration Command Summary
Step Command
Step 1
Download the ASE product-specific MIBS.
Step 2 Enable SNMP on the ASE Device.
(config)#snmp-server
Step 3 Create SNMP Users
16
SNMP in the NetVanta 1570
Explanation
Visit Adtran's website at the following link:
https://supportcommu-
nity.adtran.com/t5/Gen-
eral-MIBs/bd-p/sw-general-mibs
select NetVanta 1570.
Enable the SNMP engine on the NetVanta
1570.
Enter your SNMP community secret and
optionally specify the IP address from which
the community will accept SNMP requests.
This step is only needed for firmware ver-
sions v20.12-4 and earlier. The security mod-
els are turned off by default in firmware
v20.12-4 and earlier. These models need to
be enabled for SNMP to work on the ASE
device.
The read and write communities are disabled
by default for network safety purposes and
must be enabled for SNMP to work on the
ASE device.
Explanation
Visit Adtran's website at the following link:
https://supportcommu-
nity.adtran.com/t5/Gen-
eral-MIBs/bd-p/sw-general-mibs
select NetVanta 1570.
Enable the SNMP engine on the NetVanta
1570.
and
and
6AMCCG0018-29A