Activate And Verify The Switch; Connect To A Management Console - Extreme Networks ExtremeSwitching 5320 Series Hardware Installation Manual

Activate and Verify the Switch

Connect to a Management Console

Log in for the First Time on Switch Engine
Configure a VLAN and a Virtual Router to Use a Front Panel Port for Local
Management
Change the Switch OS via the Bootloader Menu
Change the Switch OS via the Startup Menu
Log In for the First Time on Fabric Engine
Operating system selection and activation can be done via the following:
1. XIQ - automatically by pre-selecting the preferred switch OS
2. Bootloader menu - option to change the switch OS on initial activation only
3. Startup menu in Switch Engine CLI - post-Bootloader menu prompt
Read Me First - Switch OS Selection for Universal Hardware shipped with
Refer to
your switch, or visit
information on changing your switch OS after initial activation.
Otherwise, follow the instructions in these topics:
•
Connect to a Management Console
•
Log in for the First Time on Switch Engine
•
Configure a VLAN and a Virtual Router to Use a Front Panel Port for Local
Management
•
Change the Switch OS via the Bootloader Menu
•
Change the Switch OS via the Startup Menu
•
Log In for the First Time on Fabric Engine
Connect to a Management Console
Connect each switch's serial console interface (an RJ45 jack) to a PC or terminal. The
PC or terminal serves as the
switch.
The default communication protocol settings for the serial console interface are:
•
Baud rate: 115200
•
Data bits: 8
on page 81
on page 83
https://www.extremenetworks.com/support/switch-os-selection/
on page 81
on page 83
management console , used to monitor and configure the
ExtremeSwitching 5320 Series Hardware Installation Guide
on page 82
on page 84
on page 85
on page 86
on page 82
on page 84
on page 85
on page 86
for
81