Log In For The First Time On Fabric Engine - Extreme Networks ExtremeSwitching 5320 Series Hardware Installation Manual

Log In for the First Time on Fabric Engine
What to Do Next
After resetting, your switch will boot with Fabric Engine. See
Fabric Engine
Log In for the First Time on Fabric Engine
Before You Begin
Note
Fabric Engine does not support models 5320-24T-4X-XT and 5320-24T-24S-4XE-
XT.
Onboard your switch with ExtremeCloud™. Log in or create your XIQ administrator
account in order to select your switch operating system with XIQ at
extremecloudiq.com.
About This Task
To perform the initial login and complete initial configuration tasks, follow these steps.
Procedure
1. Using a terminal emulator such as PuTTY or TeraTerm, connect to the switch using
the serial port connection.
Be sure that your serial connection is set properly:
•
Baud rate: 115200
•
Data bits: 8
•
Stop bit: 1
2. Press [Enter] one or more times until you see the login prompt.
3. At the login prompt, log in using the default user name rwa.
For example:
login: rwa
When prompted for the password, enter rwa.
When you are logged in with the role-based authentical level of rwa, you can
configure the login and password values for the other role-based authentication
levels.
86 ExtremeSwitching 5320 Series Hardware Installation Guide
on page 86 for more information.
Activate and Verify the Switch
Log In for the First Time on
https://