3.4
Initial Start-Up
Attention!
Before initial start-up please take care that your centrifuge is orderly installed
(refer to chapter 3.2 "Installation").
3.4.1
Switching on of the Centrifuge
Press mains switch (on the right side panel).
− The centrifuge display is illuminated.
3.4.2
Opening of the Lid
Press the lid-key.
− The lid opens.
3.4.3
Installation of a Rotor
Put a rotor onto the shaft and fasten it by screwing the rotor tie-down screw
clockwise onto the drive shaft. Please use the supplied rotor wrench (refer to
chapter 3.3 "Installation of rotors and accessories").
Operating Manual SIGMA 2-16K, page 31 of 61
03/06