Initial Start-Up; Switching The Centrifuge On; Opening And Closing The Lid - Sigma 2-6E Operating Manual

5.2

Initial Start-Up

Before the initial start-up, please ensure that your centrifuge is properly set
up and installed (see 4.2 "Installation", page 22).
5.2.1

Switching the Centrifuge ON

Press the mains power switch on the right side of the front (see Fig. 5.1, page
•
23).
The centrifuge display then illuminates.
5.2.2

Opening and Closing the Lid

The lid can be opened if the centrifuge is at a standstill and if the lid key is
illuminated.
Press the lid key in order to open the lid (see 5.3.7 "Activating/Deactivating
•
the Automatic Lid Opening Function", page 37).
The centrifuge cannot be started if the lid is opened.
To close the lid, press with both hands on the left and right side of the lid to
•
ensure that both of the lid locks lock into place.
Do not hold your fingers between the lid and the housing when closing the
lid. Risk of crushing!
Attention!
A flashing lid key indicates that only one lid lock has locked.
Version 04/2008, Rev. 1.18 of 07/06/2012
Translation of the original operating manual
page 27 of 65