Table of Contents
Advertisement
40
PTO
BStationary PTO
To park the tractor and use the rear PTO system (for
chipper or pump, for example), start the PTO system in
the following steps.
1. Apply the parking brake and place blocks at the tires.
2. Make sure that the speed control pedal and all shift
levers are at "NEUTRAL", and start the engine.
3. Set the rear PTO gear shift lever to either "540 rpm" or
"800 rpm" position, and set the PTO clutch control
switch to "ON" position.
4. Set the engine speed to provide recommended rear
PTO speed.
5. Get off the tractor.
(1) Parking brake lever
(1) PTO clutch control switch
(2) Rear PTO gear shift lever
A Make sure the mid-PTO gear shift lever is set to "OFF"
position.
(A) "PULL"
| :
"ON"
:
"OFF"
(A) 540 rpm
(B) 800 rpm
(N) "NEUTRAL POSITION"
(1) Mid-PTO gear shift lever
A If the rear PTO system is engaged and the parking
brake is released, the engine stops automatically.
BPTO Shaft Cover and Shaft Cap
Keep the PTO shaft cover in place at all times.
Replace the PTO shaft cap when the shaft is not in use.
When connecting or disconnecting the joint to PTO shaft,
raise up the PTO shaft cover.
(1) PTO shaft cover
(A) "NORMAL POSITION"
(2) PTO shaft cap
(B) "RAISED POSITION"
A The universal joint of the PTO drive shaft is technically
limited in its moving angle. Refer to the PTO Drive
Shaft Instructions for proper use.
"OFF"
Advertisement
Table of Contents
