Table of Contents
Advertisement
EVERY 400 HOURS
BChanging Transmission Fluid / Replacing
Hydraulic Oil Filter
C Cleaning Magnetic Filter
To avoid personal injury or death:
A Be sure to stop the engine before changing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the drain plugs at the bottom of the
transmission case and drain the oil completely into the
oil pan.
2. After draining reinstall the drain plugs.
(1) Drain plugs
3. Remove the oil filter.
4. Wipe off metal filings from the magnetic filter with a
clean rag.
(1) Hydraulic oil filter
(2) Magnetic filter (Wipe off metal filings)
5. Put a film of clean transmission oil on the rubber seal
of the new filter.
6. Quickly tighten the filter until it contacts the mounting
surface, then tighten it by hand an additional 1/2 turn
only.
7. Fill with the new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS" in "MAINTENANCE" section.)
8. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
9. Make sure that the transmission fluid doesn't leak past
the seal on the filter.
Oil Capacity
(1) Dipstick
(A) Oil level is acceptable within this range.
(2) Oil inlet
A To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
A Do not operate the tractor immediately after changing
the transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
BReplacing Fuel Filter Element
(See "Cleaning Fuel Filter" in "EVERY 100 HOURS" in
"PERIODIC SERVICE" section.)
PERIODIC SERVICE
24 L
83
Advertisement
Table of Contents
