Cleaning Inner Air Filter; Cleaning Fresh Air Filter - Kubota STW34 Operator's Manual

C Adjusting procedures
1. Detach the snap ring.
2. Loosen the tie-rod nut.
3. Turn the tie-rod joint to adjust the rod length until the
proper toe-in measurement is obtained.
4. Retighten the tie-rod nut.
5. Attach the snap ring of the tie-rod joint.
(1) Snap ring
(2) Tie-rod nut
(3) Tie-rod joint
BCleaning Inner Air Filter
[CAB Model]
Remove the inner filter, and blow air from the direction
opposite to the filter's normal air flow.
Pressure of compressed air must be under 205 kPa
(2.1 kgf/cm , 30 psi).
(1) Inner air filter
(2) Screw
BCleaning Fresh Air Filter
[CAB Model]
Remove the knob bolts and pull out filter.
(1) Fresh air filter
(2) Cover
(3) Knob bolt
A Attach the filter and cover as the illustration above.
C Cleaning the air filter
A Normal use
Blow air from the opposite direction to the filter's
normal air flow.
Pressure of compressed air must be under 205 kPa
(2.1 kgf/cm , 30 psi).
PERIODIC SERVICE
(A) Air inlet port
81