Connecting Xr Aluma-Pro, Xr Aluma-Pro Lite, Xr Edge, Xr-A Gun, Or Xr-A Python - Miller Millermatic 252 Owner's Manual

5-6. Connecting XR Aluma-Pro, XR Aluma-Pro Lite, XR Edge, XR-A Gun, Or XR-A
Python
3/32 in.
(2.4 mm)
3
2
allen_wrench allen_set
pliers needlenose
solderiron
stripcrimp
torque screwdriver
socket wrench
torque wrench
OM-230693 Page 18
�
Complete Parts List is available at www.MillerWelds.com
tools/
flathead
knife steelbrush
1
heavy-duty workclamp light-duty workclamp
drill
�
1 Gun End
2 Gun Liner
3 Wire Outlet Guide
�
Trim excess liner from end of gun so no
more than 3/32 in. (2.4 mm) of liner extends
past wire outlet guide.
4 Gun Securing Knob
4
Loosen securing knob. Insert gun end
through opening until it bottoms against drive
assembly (make sure gun end does not
touch drive rolls). Tighten knob.
Be sure to change drive rolls to the proper
size and type.
5 Gun Trigger Plug
Insert plug into receptacle, and tighten
threaded collar.
�
philips head wrench
nutdriver
wirecutter
5
Ref. 804910-B / 804936-A
greasegun
XR Edge guns prior to serial no.
LE079101 require an adapter cord
(part no. 195498).
Be sure to trim liner to proper
extension.
If Aluma-Pro push/pull gun has a listed
SUP value, set the power source to
match the SUP value (see Section 6-
5).
3/4, 5/8 in.
crescent wrench
chippinghammer
frontcutter
filterwrench