Section 4 − Installation; Installing Work Clamp; Connecting Welding Gun - Miller Passport 180 Owner's Manual

4-1. Installing Work Clamp

Tools Needed:
3/8, 7/16 in

4-2. Connecting Welding Gun

6
1 Gun Securing Knob
2 Gun Block
3 Gun Outlet Wire Guide
Loosen knob, insert gun end into block. Po-
sition outlet wire guide as close as possible
to drive rolls without touching. Tighten
knob.
SECTION 4 − INSTALLATION
2
3
1
6
) *
1
7
4 Gun Trigger Plug
5 Gun Trigger Receptacle
Connect trigger plug to receptacle.
6 Positive Weld Terminal
7 Negative Weld Terminal
8 Work Cable
4
5
5
8
4
3
2
Connect work cable to either the positive or
negative weld terminal, depending on the
wire type (see Sections 4-3 and 4-4). The
illustration shows
(DCEP) for gas-shielded wires.
9
Connect work clamp to workpiece.
1 Insulating Sleeves
2 Nut
3 Work Cable From Unit
Slide one insulating sleeve over
work cable before connecting to
clamp.
4 Work Clamp
5 Screw
6 Work Clamp Tabs
Bend tabs around work cable.
Slide insulating sleeves
handles.
802 456-A
9
803 810-A
electrode positive
Work Clamp
OM-1328 Page 11
over