Maintenance; Maintenance; Periodic Inspection And Maintenance; Maintenance Schedule - Honda HRM 520 Owner's Manual

7

MAINTENANCE

Periodic inspection and maintenance

The lawnmower must be periodically inspected and maintained for safety and to keep it running at a high
level of performance.
Periodic maintenance will also help to extend service life.
The required service intervals and the kind of maintenance to be performed are described in the following chart.
Honda recommends annual service to be completed by your local authorised Honda dealer. The dealer will
be able to perform a variety of checks and software updates that cannot be completed by the owner.

Maintenance schedule

REGULAR SERVICE PERIOD
Perform at every indicated period or operating
hour interval, whichever comes soonest.
Blade & Blade nut
*1
Blade disk
*1
Drain hole
Manual stop button
Body parts
*1
Docking station
Docking station Screws
Rear (drive) wheels
*1
Rear wheels axle
Front (caster) wheels
*1
Front caster ball bearing & bush
Frame inside
Frame seals
Obstruction sensors (case, springs and
lift washer)
Docking station (boundary wire
connectors)
Docking station (charging plug)
Mower recharging plates
Battery condition
*1 Blades, the blade nuts, the blade disk, body parts, the front (caster) wheels, and the rear (drive) wheels should be replaced as needed.
*2 These items should be serviced by your servicing dealer, unless you have the proper tools and are mechanically proficient.
Refer to Honda shop manual for service procedures.
*3 If the screws become loose, tighten them securely.
*4 Confirm using 10 last charges history.

Maintenance procedures

Dirt and grass may accumulate on the top and bottom of the lawnmower during and after mowing, and the
blades may become worn, damaged, or unable to turn. Make sure to check the lawnmower according to
the chart in "Periodic inspection and maintenance" (M page 63).
N WARNING
- Make sure to press the manual STOP button and turn the lawnmower off before performing the
following procedures.
- Put on a pair of work gloves before performing the following procedures.
- Be careful when performing the following procedures, because blades are extremely sharp.
NOTE:
- Remove the lawnmower from the docking station when performing the following procedures.
Periodic inspection and maintenance / Maintenance procedures
Every week
Check
™
Check
™
Check or clean
™
Check
Clean
™
Check
Clean
™
Check
Check or tightness ™ *
3
Clean
™
Check
Grease
Clean
™
Check
Check
Replace
Clean
Replace
Check or clean
Replace
Check
Clean
Check
Clean
Replace
Check
Every year or every 840h
operating hours. (Cutting time)
™ *
2
™
™ *
2
™
™ *
2
™ *
2
™ *
2
™ *
2
if necessary
*2
™ *
2
™ *
2
™ *
2
™ *
2
if necessary
*2
™ *
2
™ *
2
™ *
2
if necessary
*2
™ * *
2, 4
Page
(M page 68)
(M page 68)
–
(M page 65)
(M page 64)
–
(M page 65)
(M page 66)
(M page 67)
(M page 64)
–
–
(M page 64)
–
–
–
–
–
–
–
–
–
–
–
–
–
63