Table of Contents
Advertisement
Figure 25
1. Bagger lever
Holding the Bagger Door
Open
Hands, fingers and arms can get pinched
between the back and front sections of the
collector.
• Keep people away from collector while
emptying it.
• If working on the inside, use the holding
pin to hold the collector door open.
1. Disengage the PTO, set the parking brake, and
chock or block the tires.
2. Turn off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Open the bagger; refer to Opening the Bagger.
4. With the bagger open, pull out the holding pin
and insert into the hole in the hinge (Figure 26).
2. Latch lever
Figure 26
1. Holding pin
2. Hole in hinge (open)
Adjusting the Bagger Door
Opening and Cable
Adjusting the cable at the top of the bagger, can
allow the door to open farther for your desire
conditions.
1. Disengage the PTO, set the parking brake, and
chock or block the tires.
2. Turn off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Close the bagger.
4. Remove the cotter pin and clevis pin
(Figure 27).
5. Adjust the bagger cable to the desired hole
position (Figure 27).
Note: The lower hole will allow the door to
open higher. The upper hole will allow less
force to open the door while using the handle.
6. Install the clevis pin and cotter pin into the
bagger and cable end (Figure 27).
20
3. Hole in hinge (storage)
4. Hinge
Advertisement
Table of Contents
