Left Rops Mount; Right Rops Mount; Hex-Head Bolt (1/2 X 2-1/2 Inches); Locknut (1/2 Inch) - Toro 79487 Manual

Note:
Retain all wheel components for later
installation.
2
Installing the ROPS Mounts
and Lower Roll Bar
Parts needed for this procedure:
1

Left ROPS mount

1

Right ROPS mount

4

Hex-head bolt (1/2 x 2-1/2 inches)

8

Locknut (1/2 inch)

1

Left lower roll-bar tube

1

Right lower roll-bar tube

4

Hex-head bolt (1/2 x 3-1/2 inches)

Procedure
1. Install the ROPS mount to the machine frame
above the axle as shown in
on the other side.
Figure 4
Figure 5. Repeat
g464562
1. Locknut (1/2 inch)
2. ROPS mount
2. Lower a lower roll-bar tube into the ROPS mount
and secure with 2 hex-head bolts (1/2 x 3-1/2
inches) and 2 locknuts (1/2 inch) as shown in
Figure 6. Repeat on the other side.
1. Lower roll-bar tube
2. ROPS mount
4
Figure 5
Left side shown
3. Hex-head bolt (1/2 x 2-1/2
inches)
Figure 6
3. Locknut (1/2 inch)
4. Hex-head bolt (1/2 x 3-1/2
inches)
g471982
g472039