Table of Contents
Advertisement
Introduction to NAUTILUS
b-1: Bank Select button ( a-1)
b-2: PROGRAM Bank Type button ( a-2)
b-3: 10 Key
Use these keys to input a sound number for a sound in the
selected bank. The sound will switch when you press the
update (
) button.
The sound will be updated and the dialog box will close even
if you press the OK button without pressing the update
button.
Note: In Bank (10Key) display mode, the sound will change
right after you select a bank using Bank Select.
c: Category select
c-1
c-4
c-1: Category tabs
These tabs represent the sound categories.
c-2: Sub Category buttons
Use these buttons to filter down the sound category you
selected in c-1 by sub-category.
c-3: Sound list
Note: The categories and sub-categories set in "Global
Category" will be displayed (→p.178).
c-4: Scroll bar
When a list is too long for all items to fit on the screen at
once, the popup includes scroll bars. You can touch in the
empty areas of the scroll bar to move back and forth in the
list, or touch and drag the scroll handle.
Press here to scroll to left or right.
Press here and slide to left or right
to scroll to the desired location.
8
c-2
c-3
Press here to scroll to the
corresponding location.
d: Edit cell
The "edit cell" is shown as a black background in the
parameter or parameter value display. Press this to make
settings, either by pop-up or by inputting a value.
When this is pressed, the edit cell will be selected as
indicated by a green highlight. On some cells you can press
the selected edit cell a number of times to display the
numeric keypad and input a numerical value.
c-1
The parameter value of the edit cell can be modified using
the VALUE controllers. (see page 15)
In most cases you can edit the value by touching the edit cell
and dragging your finger up or down. (A few parameters
don't support this editing method.) If your hand is obscuring
the parameter value on the screen, you can drag your finger
to the left or right before editing; as long as you don't lift
your finger from the screen, the parameter will stay selected.
For parameters that accept a note number or a velocity value,
you can also hold down the ENTER button and play a note
on the keyboard to enter the note number or velocity value.
e & f: On-screen sliders, knobs, and meters
To edit an on-screen slider or knob, simply touch it and then
drag to change its value. Knobs can generally be turned by
both up-down and right-left gestures.
Alternatively, you can first touch the slider or knob and then
use the VALUE controllers to modify the value.
On-screen meters show audio levels for Combination
Timbres, Sequencer Tracks, insert, master, and total effects,
and the main output.
h: Page tabs
Press tabs to select the page.
i: Page menu button
When this button is pressed, a list of menu commands will
appear. The available commands will vary depending on the
current page. To select a command, just touch it.
The page menu will close when you press the LCD screen at
a location other than the page menu, or when you press the
EXIT button.
Even though each page may have its own unique menu
commands, the menus are standardized as much as possible.
For instance, WRITE is almost always the first menu item in
PROGRAM, COMBINATION, SET LIST, and GLOBAL
modes.
Advertisement
Table of Contents
