Korg NAUTILUS 61 AT Operation Manual page 187

Sample data may be shared by two or more Multisamples or
Drumsamples. If a Sample is used only by the Multisample
or Drumsample being unloaded, the Sample will be
unloaded as well. If the Sample is used elsewhere, it will
stay loaded.
Creating a new KSC by loading individual
Multisamples
You can also load a few Multisamples from an existing KSC,
and then save out the result as a new KSC.
Important: this example will delete any Samples or
Multisamples in SAMPLING mode! Make sure that you
save any data that you want to keep.
1. Go to the MEDIA– Load page.
2. Select a .KSC file on drive.
3. Press the Open button.
You're now looking inside the .KSC file. Even though the
.KSC file is just a list, pointing to other files, you can
browse through it on the disk as if it contained
directories. At the top level of the KSC file, you'll see
one or more folders, depending on the KSC: one for
Sampling Mode Data, and one for each referenced User
Sample Bank or EXs. If the .KSC file doesn't have a type
of data, there won't be a folder for it.
4. Select the one of the folders, and press Open to look
inside.
User Sample Data will contain one or two folders, for
Multisamples and Samples. Usually, there will be both.
EXs and User Sample Bank folders will contain one or
two folders, for Multisamples and Drumsamples.
5. Select a folder of Multisamples, and press Open to
look inside.
6. Touch the Multiple Select check-box at the bottom of
the screen, so that it's checked.
7. Touch a few Multisamples to select them.
8. Press the Load button.
9. An Are You Sure ? message appears, to confirm that
you want to load multiple files; press OK.
The Load dialog appears.
10.Set Sample & MS Allocation to Clear All.
When we save the .KSC file, we'll be including all of the
loaded samples. This option lets us start with a clean
slate.
11.If you're loading EXs or User Sample Bank data, set
the Load Method for EXs and User Sample Banks as
desired.
See "Loading into RAM or Virtual Memory" on
page 179.
12.Press OK to load the Multisamples.
Now, only the selected Multisamples are loaded.
13.Un-check the Multiple Select check-box.
In order to navigate back out of the .KSC file, this must
be disabled.
14.Press the Up button several times, until you're back at
the root level of the drive.
15.Proceed to the instructions under "Saving a KSC
file," below.
Automatically loading sample data Creating and saving .KSC files
Saving a KSC file
1. In MEDIA mode, go to the Save page.
2. In the menu, select the Save Sampling Data command.
A dialog appears. There are many options here; you can
save either Sampling Mode Data, Links to EXs and User
Sample Banks, or both. There are also various options for
saving only a single Multisample or Sample from the user
data. In this case, we're going to save everything.
3. Set Include to Both Sampling Mode & Links.
4. Set User Save Data Options to All.
5. Give the KSC file a descriptive name.
6. Press OK to save the file.
That's it! You've now created and saved your own .KSC
file. You can now load this later, or set it to automatically
load at startup.
If you've created this .KSC file as a subset of
PRELOAD.KSC to make room for other samples, make sure
to disable auto-load for PRELOAD.KSC as described under
"Selecting which KSC will be loaded" on page 179.
To reload your previous set of auto-loaded samples, follow
the instructions under "Applying changes immediately" on
page 179.
181