2.
When the power and heating LEDs are on, press and hold the Clean Cycle Button (
3 seconds. The Clean Cycle Button (
Brew Start/Stop Button (
3.
Phase 1 (Cleaning): Place two containers (~ 30 oz/~ 887 ml each) to collect water, one
under the Group Head and Water Spout, and another under the Steam Wand. Press the
Brew Start/Stop Button (
NOTE: The descaling process will run continuously, first dispensing water through the
Group Head, then the Water Spout, and finally through the Steam Wand.
4.
Once the cleaning cycle is complete, unit will start preheating, and the heating LED will
blink. When preheating is complete, the heating LED will stay on, and the
Clean Cycle Button (
cleaning cycle.
IMPORTANT: Before starting Phase 2, empty, rinse, and thoroughly clean the Water Tank.
) LED will stay on and the
) LED will flash.
) to begin the cleaning cycle.
) LED will blink, indicating it is ready to start the next phase of the
) for
35