Connecting Backup Power - Pv Point (Op); Safety - Fronius Primo GEN24 208-240 Operating Instructions Manual

Connecting backup power - PV Point (OP)

Safety

Danger from incorrect installation, commissioning, operation or incorrect use.
This can result in severe personal injury and damage to property.
▶
▶
▶
▶
Danger from damaged and/or contaminated terminals.
This can result in severe personal injury and damage to property.
▶
▶
▶
Limited rapid shutdown function in backup power mode (PV Point and Full
Backup)
If PV Point or Full Backup is configured, rapid shutdown cannot be triggered via
the loss of grid connection. This can result in serious personal injury and damage
to the PV system.
▶
NOTE!
Power supply via the PV point is dependent on the available PV output
If the PV modules are not supplying enough power, interruptions may occur.
▶
IMPORTANT!
The valid national laws, standards, and provisions, as well as the specifications of
the relevant grid operator are to be taken into account and applied.
It is highly recommended that the specific installation be agreed with the grid
operator and explicitly approved by this operator. This obligation applies to sys-
tem constructors in particular (e.g., installers).
WARNING!
Single 120 / 220 / 240 volt supply. Do not connect multi-wire branch circuits!
Only trained and qualified personnel are authorized to install and commis-
sion the system, and only within the scope of the technical regulations.
The Installation Instructions and Operating Instructions must be read care-
fully prior to use.
If anything is unclear, contact your vendor immediately.
WARNING!
Prior to connection work, check the terminals for damage and contamina-
tion.
Remove any contamination while the equipment is de-energized.
Have defective terminals replaced by an authorized technician.
WARNING!
A WSD switch must be installed for all backup power modes (PV-Point and
Full Backup) (see Installing the WSD (wired
is then triggered via WSD.
Do not connect any loads that require an interruption-free supply.
shutdown)). The rapid shutdown
59