Fronius Primo GEN24 208-240 Operating Instructions Manual page 51

2
3
4
Loosen the five screws of the connec-
tion area cover by rotating them 180°
to the left using a screwdriver (TX20).
Remove the connection area cover
from the device.
Guide the mains cable from below
through the electrical installation tube
on the right side.
Remove the AC terminal.
Strip the insulation of the single con-
ductors by 0.47 inches.
The cable cross-section must be selec-
ted in accordance with the instructions
Permitted cables for the electrical
in
connection from page 45.
Lift to open the terminal's operating
lever and insert the stripped single
conductor into the slot provided as far
as it will go.
Then close the terminal's operating
lever until it engages.
NOTE!
Only one conductor may be connected
to each pin.
The AC cables can be connected to
the AC terminals without ferrules.
51