Table of Contents
Advertisement
Original installa�on and opera�on manual
7.2.6
Remote RESET digital input
NOTE
Illustration
54 | 120
Remote electrical contact
Using an unsuitable remote electrical contact may cause operating malfunctions.
•
Use only a clean remote contact suitable for low voltage applications and
free from any electrical potential.
•
Max resistance of contact + cable: 100 ohm.
Connection work
Description / explanation
1. Guide a two-wires signal cable through
the arranged rubber grommet on the
product.
2. Product side: Connect the cable to the
connector M10 [DI8-GND] REMOTE
RESET of Electronic Control Unit.
3. Plant side: connect the cable to the
remote electrical contact.
4. Make sure that power cable is free of
mechanical stress and mechanically
protected.
DRYPOINT
®
RA III
Advertisement
Table of Contents
