Adjustment Of Hot Gas By-Pass Valve - Beko DRYPOINT RA III 1080 Translation Of Original Installation And Operation Manual

DRYPOINT ® RA III

11.2.1 Adjustment of hot gas by-pass valve

NOTE
INFORMATION
Schrader service valve
Each time a pressure gauge is connected to the Schrader service valve, a part of
refrigerant fluid is discharged in the environment.
•
Connect the pressure gauge to the Schrader service valve only in case of
real malfunction of the refrigerant circuit.
Factory setting of hot gas by-pass valve
The hot gas by-pass valve is adjusted by the manufacturer during the testing phase
of the device and the adjusting screw is sealed with yellow sealant.
In case of malfunction of refrigerant circuit, is possible to recalibrate the by-pass
valve.
Original installa�on and opera�on manual
91 | 120