Slip Roll Maintenance - Baileigh Industrial 3-IN-1 Operator's Manual

SLIP ROLL MAINTENANCE

Every (6) months remove and lubricate the roller bushings.
1. With the aid of an assistant carefully remove the top front roll. To do so, back off both top roll
adjustment bolts, and rotate the roll release pin (left side of roll), 90°. Be careful not to
damage the roll.
2. Remove both bushings from the ends of the roll.
3. With mineral spirits, wipe all old grease from the bushings, gears, roller end shafts, and
machined pockets that the bushings rest on.
4. After the parts have dried, lubricate them sufficiently with multi-purpose grease.
5. Apply some 10W30 or equivalent oil into the bushings of the bottom front roll.
6. Lower the idler roll by turning the (2) idler adjustment bolts counterclockwise (ccw). This will
give you access to apply oil to the bushings. (fig. 20)
7. Remove the idler adjustment bolts and clean the threads. Lubricate with oil and re-install.
(fig. 19).
Idler Adjustment
Bolts
figure 19
30
30
Oil
figure 20