Rolling Round Shapes - Baileigh Industrial 3-IN-1 Operator's Manual

CAUTION:
finished cylinders from the top roll. Failure to adequately support the top roll may
result in the roll falling, and causing personal injury.
11. Turn the notched shaft and slip the upper roll cylinder out
to remove the work piece (fig 16).
12. With the help of an assistant, lift the left end of the top roll,
up and out, keeping the right end gears meshed as much
as possible. The other person will slide the finished
cylinder off. The roll is heavy, so DO NOT attempt this
alone.
Note: Wire rolling is done the same way.
Choose the same size groove on the upper and lower
cylinders to match the wire gauge you are rolling.

Rolling Round Shapes

There are three wire or forming grooves located on the end of the
upper and lower rolls (fig. 17). They can be used to form solid wire,
rods, and small tubing.
To make rings, follow the "Determining Length of Material"
procedure to calculate the actual length. Then proceed with the
rolling operation.
Have an assistant support the top roll when removing
27
27
figure 16
figure 17