Shearing Sheet Metal - Baileigh Industrial 3-IN-1 Operator's Manual

SHEARING SHEET METAL

WARNING:
is firmly bolted to a table, bench, or the floor. If it tips over on you, it could cause
severe injury or death.
WARNING
no body part or clothing is near the specific hazard. Failure to follow this warning
could result in severed or crushed fingers.
CAUTION:
footwear, and leather gloves to protect from burrs and sharp edges.
1. Adjust the rear stop (#48) to accommodate the
length of the cut (fig. 5).
2. Using the handle assembly, raise the upper
blade to the highest position.
3. Have at least one square edge of the material
against the side guide or the adjustable rear stop
for accurate cuts.
4. Lay the sheet metal on the work apron against
the left side guide. Push the sheet under the hold
down until it bumps up to the adjustable stop.
Before operating the Baileigh Shear, Brake, Roll make sure it
: The shearing blades pose an amputation hazard. Make sure
Always wear proper eye protection with side shields, steel toe
48
17
17
figure 5