Lubrication And Maintenance; Oil Disposal; Storing Machine For Extended Period Of Time - Baileigh Industrial TN-600 Operator's Manual

LUBRICATION AND MAINTENANCE

WARNING:
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.
 Check daily for any unsafe conditions and fix immediately.
 Check that all nuts and bolts are properly tightened.
 On a weekly basis clean the machine and the area around it.
 Lubricate threaded components and sliding devices.
 Apply rust inhibitive lubricant to all non-painted surfaces.
 Remove the grinding debris as often as practical with a vacuum or light air blast.
 Check bearings periodically for smooth operation, a rough rolling bearing will wear out
quickly and should be replaced immediately
 Keep slide surfaces clean from grinding debris
 Be sure always to use good belts, old belts can break easily and will decrease the
performance of the machine and may be unsafe.
 Periodically check the power cord for cuts or bare wire and replace if damaged.

Oil Disposal

Used oil products must be disposed of in a proper manner following your local regulations.

Storing Machine for Extended Period of Time

If the Vertical Milling Machine is to be inactive for a long period of time, prepare the machine as
follows:
 Disconnect the electrical supply from the power panel.
 Empty and clean the coolant reservoir.
 Clean and grease the machine.
 Cover the machine.
Note: Proper maintenance can increase the life expectancy of your machine.
Make sure the electrical disconnect is OFF before working on
21
21