Assembling The Manifold On The Condensation Module - Immergas Victrix Tera V228 EU Manual

3.25 ASSEMBLING THE MANIFOLD ON THE CONDENSATION MODULE

1. Place the manifold (2, Fig. 66 or Fig. 67) on the module (3, Fig. 66 or Fig. 67).
2. Tighten the 4 nuts (1, Fig. 66 or Fig. 67) on the condensation module (3, Fig. 66 or Fig. 67) in the sequence (A, B, C, D of Fig. 66 or Fig. 67)
shown in the drawing.
The tightening torque when assembling the manifold (2) on the condensation module (3) must be 4 Nm.
Do not exceed 5 Nm.
Victrix Tera V2 28 EU - V2 32 EU
Victrix Tera V2 38 EU
A
1
D
A
1
D
C
B
C
B
3
2
1
3
2
1
66
67
89