Ap16 System Layout; Rf300 Rudder Feedback Installation - Simrad AP16 Manual

Notes!
1. On boats powered by outboards or stern drives it may be
2. In order to benefit from the virtual feedback technology your
3.5

AP16 System Layout

3.6

RF300 Rudder feedback installation

The RF300 Rudder feedback unit mounts close to the rudder,
and is mechanically linked to the rudder tiller arm or rudder
quadrant.
Refer to Figure 3-2 for the recommended mounting arrangement.
Note that the RF300 transmitter arm has two slots for the
20221560E
difficult to install a rudder feedback unit (chapter 3.6 and
3.27). Use of the Virtual feedback algorithms in the software
may then be preferred as this requires no installation of a
rudder feedback unit (page 95). The Virtual Feedback can
be used on boats up to 40 ft.
autopilot system must be using a Simrad rate compass for
heading information.
STBY
10
AUTO 10
PW R
1 1
INFO NAV
TUR N
SETUP WIND
DODG E
Figure 3-1 AP16 system layout with options
STBY
10
AUTO 10
PW R
1 1
INFO NAV
TURN
SETU P WIND
DO DG E
Installation
STBY AUTO
SIMRAD R3000X
STBY AUTO
PWR SPEED
NAV
SETUP TURN
55