Ap25 System Layout; Rf300 Rudder Feedback Installation - Simrad AP25 Manual

Notes!
1. On boats powered by outboards or stern drives it may be
2. In order to benefit from the virtual feedback technology your
3.5

AP25 System Layout

3.6

RF300 Rudder feedback installation

The RF300 Rudder feedback unit mounts close to the rudder,
and is mechanically linked to the rudder tiller arm or rudder
quadrant.
Refer to Figure 3-2 for the recommended mounting arrangement.
Note that the RF300 transmitter arm has two slots for the
20221495F
difficult to install a rudder feedback unit (chapter 3.6 and
3.27). Use of the Virtual feedback algorithms in the software
may then be preferred as this requires no installation of a
rudder feedback unit (page 109). The Virtual Feedback can
be used on boats up to 40 ft.
autopilot system must be using a Simrad rate compass for
heading information.
Figure 3-1 AP25 system layout with options
STBY STBY
PW R PWR
AU TO AUTO
SPE ED SPEE D
NAV NAV
SETU P SE TUP
INSTR INSTR
MENU TURN MENU
Installation
STBY AU TO
TU RN
SIMRAD R3000X
STBY AUTO
PW R SP EED
NAV
SETU P TUR N
67