Simrad B&G NAC-3 - Autopilot System Installation Manual

Also See for B&G NAC-3:

Installation manual (2 pages)

Commissioning manual (25 pages)

Table of Contents

Contents

1 Parts included
2 Dimensions
3 System wiring example
4 Mounting
5 Terminal access
6 Terminal layout
7 Grounding
8 Power
9 Network
10 Remotes
11 Drive units
12 Rudder Feedback
13 NMEA 0183
14 External Alarm
15 External System Selector
16 External I/O
17 Documents / Resources
- 17.1 References
- 17.2 Download manual

Simrad B&G NAC-3 - Autopilot System Installation Manual

Parts included

1 x NAC-3 Autopilot Computer - IPX7
4 x Fixing screws
1 x Micro-C Drop cable (male) - 0.6 m
1 x Micro-C T-Joiner
7 x Connectors
1 x 30 Amp fuse
Spare cable grommet
Warranty card & literature pack

Dimensions

System wiring example

	Power
	NMEA 2000 Backbone
	Micro-C Drop cable
	Rudder Drive & Feedback cable

NMEA 2000 Backbone
Micro-C Drop cable
Micro-C Power cable
Micro-C T-Joiners
Micro-C Terminator, 120 Ohm
Rudder drive & Feedback cable

Mounting

Terminal access

Terminal layout

Grounding

Power

CONNECT WIRES
CHECK POLARITY
INSTALL FUSE
POWER ON

Network

Remotes

Drive units

(Max 8A/12A Continuous/Peak)
Drive units
* Solenoid valves, 12 or 24V DC, powered from NAC-3 Autopilot
NOTE: NAC-3 Autopilot cannot operate externally powered solenoids unless installing isolating relays.

Rudder Feedback

(Frequency rudder feedback)

NMEA 0183

External Alarm

External System Selector

External I/O

For setup instructions, commissioning guide, product manuals, technical specifications, certificates and declarations, refer to the product website:
www.simrad-yachting.com
www.bandg.com