Table of Contents
Advertisement
3
INSTALLATION
3.1
General
This section provides detailed information required to
successfully installing AP16 Autopilot system.
The AP16 system includes several modules that need to be
mounted in different locations on the boat, and also need to
interface with at least three different systems on the boat:
In addition, the advanced capabilities of the AP16 require the
installer to perform a series of settings and tests to verify proper
operation of the system, refer to the check list below.
3.2
Installation checklist
1. Determine system configuration you are installing (Page 54)
2. Perform the hardware installation (Page 55)
3. Connect SimNet devices to SimNet (page 70)
4. Connect NMEA2000 devices (page 73)
5. Connect NMEA 0183 devices (inputs and outputs, page 76)
6. Perform Set-up (page 83)
7. Perform dockside autopilot tests (refer to Operating
8. Perform sea trial settings (Page 98)
20221560E
−
The boat's steering system
−
The boats electrical system (input power)
−
Other equipment on board (NMEA interfacing)
Instructions, page 15)
a) Test all stations (if applicable) - lock/unlock - active/
inactive
b) Test Non-Follow Up mode
c) Test Follow-Up mode
d) Test AUTO mode
e) Test NAV mode and input interfaces
f) Test WIND and WIND
interfaces
g) Test interface outputs to external equipment (if
connected)
a) Rudder zero
b) Compass calibration
c) Compass Offset adjustment
modes (if sailboat) and input
N
Installation
53
Advertisement
Table of Contents
