Table of Contents
Advertisement
System Data Menu
To exit the menu, press any mode key (STBY, AUTO or NAV).
SimNet and NMEA Data Screen
20221560E
Configuration and setup
Select System data by pressing the
STBY 10 button.
Steer compass
Steering Compass readout,
M=Magnetic, T=True
Rudder
Rudder angle. Normally between zero
and 45 degrees.
Input voltage
Mains voltage on input terminals.
Drive out
Power needed to drive the unit in
percent of full (100%) to get
satisfactory rudder speed.
Clutch/bypass
Verifies if a clutch or bypass valve
has been activated when performing
the rudder test.
Select STANDBY mode.
Press en hold the NAV/WIND button
for 5 seconds to enter the Installation
Menu.
Press the STBD 1 button to select
"SERVICE".
Confirm by pressing the STBD 10
button.
113
Advertisement
Table of Contents
