Determining System Configuration; Ap50 System Layout - Simrad AP50 Instruction Manual

4.4 Determining System Configuration

4.5 AP50 System Layout

GI UNIT
(future option)
ELECTRONIC
CHART
HS50
SYSTEM
GPS/
CHART
PLOTTER
BOAT'S
MAGNETIC
COMPASS
CD100A
* SYNCHRO 1:1, CD100A, SINE/COSINE MAGNETIC COMPASS
** STEPPER GYRO, GEARED SYNCHRO GYRO, PULSE-LOG
Note !
20221032B
It is important to become familiar with the configuration of the
system prior to beginning the installation. The AP50 Basic
system is shown in Figure 1-1 on page 13 and an extended
system is shown in Figure 4-1 on page 73.
Pay particular attention to the junction unit/drive unit
combinations on page 89 and the junction units chart on page
14.
As many of the units are communicating on a common network
(RobNet) with identical connectors, the installation is simplified.
Mount the units within the standard cable length supplied with
each unit, if possible (refer to Technical Specifications, section
3, beginning on page 49. RobNet Extension Cable (10m) is
available from your Simrad distributor. Refer to the Spare Parts
List on page 170 for part numbers.
RC25/RFC35R
CI300X NI300X
RADAR CLK/DATA
EXT. ALARM
GYROCOMPASS
MAINS
WINDVANE
GI50
RFC35R
CDI35 (Alternative
connection)
Figure 4-1 AP50 Extended system with options
The extended system layout does not show all possible layouts.
AP50
ROBNET
J50/
J50-40
NON
SIMRAD
S35
COMPASS
3- or 4-WIRE
NMEA DATA
2-WIRE FREQ. 2-WIRE FREQ.
RF300S
Installation
AP50
AP51
RI35 MK2
TI50
S100 R3000X F1/2 NFU
REVERSIBLE
SOLENOID
PUMP VALVE
RF45X
FU50
AD50
RF14XU
73