Ap27 Connection; Rfc35 Fluxgate Compass Installation - Simrad AP16 Manual

CONTROL UNIT
J1 and J2 (left) are Robnet2 connectors. J3 and J4 are SimNet
connectors.

AP27 connection

If a Simrad AP27 is part of the system, use the JP27 Jack Point
and connect as shown on Figure 3-9. Alternatively cut the
connector from the cable and connect the wires in parallel with
the cable shown on Figure 3-11 using the same color code.
Note ! The AP27 cable contains an air-breathing tube. Check that the
tube is open after you have cut the cable.
3.13

RFC35 Fluxgate Compass installation

The heading sensor is the most important part of the AP16
system and great care should be taken when deciding the
20221560E
AP16
REAR VIEW
Figure 3-11 Control unit connection
Figure 3-12
RFC35 mounting
AUTOPILOT COMPUTER
MA IN PCB
Installation
TB15
Bn
Wh Pnk Gry Yel
ROBNET
67