Configuration And Setup; First Time Turn On - Simrad AP16 Manual

4

CONFIGURATION AND SETUP

4.1

First time turn on

Before attempting to turn on the AP16 and perform an
Installation Setup, the hardware installation and electrical
connections must be completed in accordance with the
installation instructions.
The design of the AP16 includes advanced features that have
simplified the installation and setup of an autopilot.
Note ! If the autopilot is going to use Virtual feedback (page 55) you
must first go to page 95.
Notes !
1. You can postpone the automatic interface by going directly to
2. Be aware that you will have no compass reading before the
Continue by pressing the STBD 1 button to start the automatic
interface set up.
20221560E
This is the start-up screen that is presented the first
time you turn on your autopilot by pressing the
STBY/PWR button.
the Installation/Dockside setup. Any time the STBY button is
pressed the interface prompt will reappear until the
automatic interface has been performed.
automatic interface is completed.
The autopilot will search for connected sources,
and as the sources are detected a black square
appears on the screen.
"SEARCHING" is flashing as long as the autopilot
is searching for data. When the automatic interface
setup is finished, "Done Press →" is displayed.
Press the STBD 1 button and the display will read:
"SETUP REQUIRED".
Continue with the installation setup according to
the next chapters. If you already have completed
the installation settings, the autopilot will enter
STBY mode.
Configuration and setup
83