Goodwe SDT Series User Manual page 55

User Manual V1.3-2024-01-25
Parameters
Set ISO
LVRT
HVRT
Power Limit
SetPowerLimit
Pv1ShadowMPPT
Pv2ShadowMPPT
PvTimeInterval
SetModbusAddr
SetSunspec
ARC Enable
ARC SelfCheck
ARC FaultClear
Set Password
Set Grid Type
Set N-PE
Reset Settings
ViewFaults
ClearFaults
Description
Indicates the PV-PE insulation resistance threshold value. When the
detected value is under the set value, the IOS fault occurs.
With LVRT on, the inverter will stay connected with the utility grid
after a short-term utility grid low voltage exception occurs.
With HVRT on, the inverter will stay connected with the utility grid
after a short-term utility grid high voltage exception occurs.
Set the power fed back into the utility grid according to the actual
situation.
Enable the shadow scan function if the PV panels are shadowed.
Set the scan time according to the actual need.
Set the actual Modbus address.
Set the Sunspec based on the actual communication method.
The function is optional and off by default. Please open or close it
according to actual need.
Detect if the ARC function is normal.
Clear the ARC Fault.
The password can be adjusted. Please record the new password
and if you lose the password, please contact the after-sales service
center.
Set the grid type according to the actual situation. Star and Delta grid
are supported.
To enable the detection of N line to ground insulation resistance.
Restore part of factory settings.
Check historical fault records of the inverter.
Clear historical fault records of the inverter.
51
08 System Commissioning