Table of Contents
Advertisement
Chapter 5 – Configuration
Accessing the main menu
The section describes in detail the steps needed to call up the main menu using both the
Monitor Utility and Control Panel.
Accessing the main menu using Monitor Utility
1. Run HyperTerminal (or the terminal program used to establish an RS232 connection with
ACS-8990) and open the connection established with ACS-8990 in Chapter 4.
2. Press Ctrl D to launch the Monitor Utility.
When ACS-8990 boots up, it enters Self-Diagnostic Mode and runs diagnostic tests. The
first test covers the CPU and supporting core logic chips, the internal bus, memory, SCSI
controller, Serial ATA controllers, and RS-232 controllers. The second diagnostic test
checks for the presence of disks on each individual disk channel and the functionality of
each disk found. The final diagnostic test checks RAID functionality.
The messages shown on the right will
display as ACS-8990 runs through the
tests. When complete, ACS-8990 will
enter Operation Mode and the Monitor
Utility window will show. The menu area
will be blank.
3. The Output area is active, press Tab once to switch to the Menu area.
4. With the Menu area active, press Enter. You will be prompted to enter a password.
LCD initialize OK
Memory sizing...256MB
Memory testing.......OK
Move ROM code to System Memory...OK
Jump to System Memory
Startup system, please wait...
45
Advertisement
Table of Contents
