Setting fibre channel parameters
The parameters of the fibre channel connection(s) to the host(s) are set and reconfigured
from the FC (fibre channel) params submenu located at Main menu > FC params menu.
2 Fibre paramn
2.1 Primary FC
2.2 Secondary
FC*
*submenus as for
Primary FC
2.3 SAN Mask
56
ACS-8990/89200/89230 User's Manual
ACS-8990 is available in two hardware configurations: With a fibre channel
interface and with a SCSI interface. The FC Params menu is only present on
the fibre channel interface configuration. User of the SCSI interface model
should ignore this section.
2.1.1 Enable Hard
Enable / Disable
Loop ID
2.1.2 Set Hard Loop ID
2.1.3 Set Connection
Arbitration Loop /
Mode
Point-To-Point
1 Giga Bits / 2 Giga Bits /
2.1.4 Set Data Rate
Auto-Negotiated
Match slices in existing
2.1.5 Lun map
arrays to up to 128 LUNs
2.3.1 Visible for all
2.3.1.1 Port1
hosts
2.3.1.2 Port2
2.3.2 SAN Mapping
2.3.2.1 Port1
2.3.2.2 Port2*
2.3.3.1~2.3.3.9
2.3.3 Edit WWN Table
Select Host
2.3.4 View WWN
Table
2.3.5 View SAN
2.3.5.1 Port1
Mapping
2.3.5.2 Port2
Enable /
Disable
Enable /
Disable
2.3.2.1.1~2.3.2.1.9
Select
Select Host
LUN
*Submenus a for 2.3.2.1 Port1
Yes /
No