Table of Contents
Advertisement
Changing hardware configurations
Most users should not need to replace components but users need to remove components to
install or remove a DDR RAM module. Instructions on installing and removing DDR RAM are
given separately in the next section. This section provides instructions for the removal and
installation of the following components:
Control Panel
Backplane
Daughterboard
Controller board
In order to access internal components:
1. Remove any screws securing the top
cover.
2. Remove the cover by sliding it back and
lifting off.
The position of the removable components is
shown in the figure on the right.
24
ACS-8990/89200/89230 User's Manual
Read the pre-installation notices earlier in this chapter before proceeding with
installation.
Advertisement
Table of Contents
