Setting Scsi Parameters; Scsi Params Menu - Accusys ACS-8990 User Manual

Chapter 5 – Configuration

Setting SCSI parameters

The parameters of the SCSI connection(s) to the host(s) are set and reconfigured from the
SCSI Params submenu located at Main menu > SCSI Params menu. The settings are needed
to avoid conflict with the SCSI adapter or other SCSI devices
2
2.1 Primary SCSI
SCSI params
2.2 Secondary SCSI*
*submenus as for Primary SCSI

SCSI params menu

2.1 Primary SCSI
Submenu for configuring Primary SCSI settings
2.1.1 Set SCSI ID
Select 0 to 15 or Multiple (Default: 0). ID 7 is reserved for the SCSI card.
2.1.2 Speed
Ultra 320, Ultra 3, Ultra 2, Ultra or Fast (Default: Ultra 320). See table below for
settings.
ACS-8990 is available in two hardware configurations: With a fibre channel
interface and with a SCSI interface. The SCSI Params menu is only present on
the SCSI interface configuration. User of the fibre channel interface model
should ignore this section.
2.1.1
Set SCSI ID
2.1.2
Speed
2.1.3
Wide
2.1.4
Lun Map
2.1.5
QAS
0 ~ 15/ Multiple
Ultra 320 / Ultra 3 / Ultra 2 / Ultra
/ Fast
Enable / Disable
Lun 0 ~ Lun #
Enable / Disable / Don't care
53