Table of Contents
Advertisement
INSTALLATION
7.4 Retrieve the inclined coupling assembly from the
packing and follow as below refer Fig.-4.
•
Install the coupling to the suspension arm by
sliding the guiding shaft (1) into the suspension
arm.
•
Lock the inclined coupling with the threaded plug
(2).
7.5 Mounting the light guide
•
Switch off the illumination system
• The light guide comes pre-routed through swivel arm
(that houses the LED illumination system) and the
suspension arm.
• Insert the light guide into the receptacle in the
microscope till it properly tighten into position as
shown as A in Fig.-5.
• Make sure that wire has been routed in such a way
that the carrier system and the surgical microscope
are not Obstructed, and that they can be moved
in their entire range of movement without stretching,
Extreme, kinking or twisting of the light guide.
7.6 Install the binocular head and eyepieces on the
magni-changer. Secure the binocular head with
head locking screw shown as (A) in Fig.-6.
6165000-795
Prima GN
PRIMA GN
1
2
Fig. 4
A
Fig. 5
A
Fig. 6
Issue 1.9
Printed on May,2023
10
Advertisement
Table of Contents
