Installation; Fastening To Floor; Installation Work By Customer; Mounting The Column - Labomed AXIUS User Manual

Centre pole

Table of Contents

5. Installation

CAUTION

Watch out for under-floor heating and cables when drilling.

Special fasteners must be used for floors made of wood, hollow blocks, etc. These are not included

in the scope of delivery. The technician is responsible for properly installing the unit with suitable

fasteners.

Identify the setup site according to the floor plan

Provide the installations at the customer's premises.

 Position the drilling template on the floor according to the template in the installation

plan and the dimensions recommended in the corresponding floor plans, and make the

markings and drill.

 Align the two notches on the inner diameter of the mounting plate 6137160-102 (see floor

plan, section A-A) parallel to the middle axis of the patient chair.

Note

The curved oblong holes in this mounting plate can be used to mount the entire column while it is

rotated by up to +/- 30° about its middle axis or in order to be able to vary the position of the floor

dowels if the floor poses problems.

 Position the mounting plate ③ with pre-mounted column ④ on the floor and screw it

down. (Fastening material is included with the accessories)

Note

Remove the profile piece ① and the clamping washer ② if the difference between the upper end

of the aluminium column profile and the ceiling is less than 250 mm.

The accessories carton contains a second profile piece and a second clamping washer. These can

be plugged onto the equalising rod if the upper pair of hoods is to be attached relatively far up.

This provides for additional supports to the cladding profiles.

Axius

Part No: 6137120-795

Issue: 1.0

Printed On: June 10, 2023

Table of Contents